There is a need to address the question about Smart Nav and Smart Nav Plus.  The easiest way to determine whether you have the plus is to look for your AM/FM antenna connector.  If you have a standard Motorola-style antenna connection, you will use the connector BT ISO DIN.  This connection is found further down in the wiring.  Follow the wires from the old connector about 6-8inches down, and you should see two 8-pin connectors.  This is where our BT ISO DIN will plug in.  If you don't have a Motorola-style connector for your antenna, you have the 1st version of SmartNav and use the SmartNav + Ant Adpt or the SmartNav + Ant Adpt. PLUS, that comes with a radio removal   Read more...

Use the BT ISO DIN for the radio.  Don't have one for the speakers.  If you don't want to cut the factory plug off the wire a pigtail for the speakers, use a T-Tap connector to wire on the new speaker   Read more...

A easy mistake is sometime a installer will determine that a wire is a ground wire when it is normally test to ground with a tester.  That same wire once the headlights are turned on will now have 12 volts on it.  It is actually a illimunition wire.  Take the ground wire loose and ground the radio to metal ground and recheck.  Hope this   Read more...

If one of our FORD harnesses does not work, it's probably because most of the RV manufacturers cut off the factory plug to attach the harness to the radio they install.  That would be a dedicated connector for just the radio itself, and there is no mate to that   Read more...

The shopping cart has a timer builtin if you are slow about adding products it might not allow.  Also to mention use the back button instead of continuing   Read more...